Unitech MS100-NUCB00-SG 1D Wand/Pen Scanner MS100

MS100 | Handheld Pen–Wand Scanner (1D)

The MS100 is a wand/pen barcode scanner, an ergonomic and compact device best suited for low-volume applications. It’s likely that a wand barcode scanner such as the MS100 offers the best form factor for your application. As the least expensive type of barcode scanner in the market, there’s a lot to be said about the lasting value of a wand barcode scanner.

Wand barcode scanners are the most accurate solution when an application calls for scanning multiple barcodes on a sheet of paper. It is much easier to run a pen scanner across the correct barcode than the alternative – aiming a laser directly on it without hitting any others accidentally. The MS100 is a plug-and-play device. No downloads are required for installation and no configuration is necessary. Simply plug the wand scanner into your computer to start working. Scan by sweeping the tip across a barcode in any direction. Listen for the confirmation beep and you’re all finished.

The MS100 can also read barcodes that are too wide for traditional barcode scanners to capture effectively.

• Reads all common 1D barcodes
• Compact and lightweight
• Plug and play
• Multiple interface options
• Ergonomic grip
• Warranty: 2 years

Physical Characteristics

Dimensions: 5.5" (140 mm) L / 1.2" (30 mm) x 0.9" (23 mm) diameter
Weight: 2.7 oz. (76 g)
Cable length: 71" (180 cm)
Case material: ABS plastic

Optical

Light source: 650 ~ 660nm red LED
Receiving device: Photo sensor
Depth of field: 0.04"
Resolution: 5 mils
Print contrast: 0.6 minimum
Scan rate: 4 – 24 inches/sec
Reading angle: 45 to 90 degree
Ambient light: 5000 Lux/Max

Data Collection

1D Laser Scanner
1D symbologies: Code 39 standard and full ASCII, EAN-13, UPC-A, EAN-8, UPC-E, standard 2 of 5, Code 128, Code 93, MSI, Code 11, Code 32, Delta Code, Label Code, Plessey Code, Codabar

Communication/Interfaces

USB
Keyboard wedge
RS-232 serial
TTL (undecoded)

Environmental

Drop specification: Multiple drops at 5 feet (1.5 m) to concrete
Operating temp: 32°F to 122°F/0°C to 50°C
Storage temp: -4°F to 140°F/-20°C to 60°C
Humidity: 20% to 85% RH non-condensing

Electrical

Supply voltage: 5V DC 10%
Surge power: < 800 mA
Working current: 60mA 10mA

Warranty/Certifications

Main unit 2 years; cables/adapters 90 days